Nissan Murano: Restraints

Steering Control System :: Removal and Installation. Power Steering Control Module

Removal and Installation CAUTION: Disconnect battery negative cable before removing the power steering oil pump assembly. The power steering control module is an integral part of the power steering oil pump assembly...

Seat Belt :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1b51-16 Blind Spot Warning Indicator Short Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B51-16 BSW/BSI IND SHORT CIR (Blind Spot Warning indicator short circuit) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Short circuit in Blind Spot Warning indicator circuit is detected...

Nissan Murano (Z52) 2015-2024 Service Manual: P0794 Intermediate Speed Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0794 INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Intermittent) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Primary pulley speed: more than 11820 rpm Diagnosis delay time Maintained 2 seconds POSSIBLE CAUSE Harness or connector (Primary speed sensor circuit is open or shorted) Primary speed sensor TCM FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed Manual mode is not activated Confirmation Procedure DTC CONFIRMATION PROCEDURECAUTION: Always drive vehicle at a safe speed...