Nissan Murano: Rear Automatic Braking (RAB) (if so equipped) / System malfunction
If the RAB system malfunctions, it will be
turned off automatically, and the RAB system
warning light will illuminate in the vehicle
information display.
Action to take
If the warning light illuminates, park the vehicle
in a safe location, turn the engine off,
and restart the engine. If the warning light
continues to illuminate, have the RAB system
checked. It is recommended that you
visit a NISSAN dealer for this service.
NOTE:
If the RAB system cannot be operated
temporarily, the RAB system warning
light blinks.
WARNING
Listed below are the system limitations
for the RAB system. Failure to follow the
warnings and instructions for proper
use of the RAB system could result in
serious injury or death...
Observe the following items to ensure
proper operation of the system:
Always keep the parking sensors
clean.
If the parking sensors are dirty, wipe
them off with a soft cloth while being
careful to not damage them...
Other information:
Exploded View
1.
Hood lock
2.
Secondary latch
3.
Hood lock release cable
4.
Hood lock release handle
Clip
Removal and Installation
REMOVALRemove core support cover. Refer to Exploded View.
Disconnect hood lock release cable and secondary latch cable from hood lock...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1232
ST ANGLE SEN CALIB
(Steering angle sensor calibration)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
—
Diagnosis delay time
—
POSSIBLE CAUSE
Neutral position adjustment of the steering angle sensor is incomplete
Steering angle sensor
FAIL-SAFEPredictive course line is not displayed
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more