Nissan Murano: Seat Belt :: Removal and Installation / Latch (lower Anchors and Tether for Children) System

Seat Belt Buckle

Removal and Installation SEAT BELT BUCKLE - (LH/CONNECTOR)RemovalRelease pawls and remove rear seat (LH) front bolt covers (1) then remove bolts. : Pawl Lift and support seat cushion (LH) using a suitable tool then disconnect seat belt buckle harness connector...

Srs Air Bag :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: A-Bag Branch Line Circuit

Diagnosis Procedure WARNING: Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other measuring device. CHECK CONNECTOR Turn the ignition switch OFF...

Nissan Murano (Z52) 2015-2024 Service Manual: U0100 Lost Communication (ecm A)

DTC Description DTC DETECTION LOGICWhen the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 seconds or more. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0100 LOST COMM (ECM A) (Lost Communication With ECM/PCM A) Diagnosis condition When the ignition switch is ON Signal CAN communication signal Threshold TCM is unable to receive the CAN communications signal from ECM Diagnosis delay time Continuously for 2 seconds or more POSSIBLE CAUSE ECM Harness or connector (CAN communication line is open or shorted) FAIL-SAFE Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure CHECK DTC PRIORITY WhenDTC U0100 is displayed together with DTC U0300, diagnose first the DTC U0300...