Nissan Murano: Srs Air Bag :: Removal and Installation / Seat Belt Pre-Tensioner
Removal and Installation
For removal and installation procedures, refer to Removal and Installation (Front seat belt) or Removal and Installation (Second row seat belt).
Exploded View
1.
Air bag diagnosis sensor unit
Front
Removal and Installation
WARNING:
Before servicing SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...
Removal and Installation
The front seat belt buckle switch is part of the front seat belt buckle. For removal and installation of the front seat belt buckle, refer to Removal and Installation...
Other information:
DTC Description
DTC DETECTION LOGIC
Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signals from ECT sensor and intake air temperature sensor.
The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, EOT sensor, and FTT sensor) shows that the voltage signal of the FTT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...
DTC Description
TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction.DTC DETECTION LOGICFlash ROM error is detected when turning ON the ignition switch...