Nissan Murano: Srs Air Bag Control System :: Dtc/circuit Diagnosis / B1427 Config Setting

Nissan Murano (Z52) 2015-2024 Service Manual / Restraints / Srs Air Bag Control System :: Dtc/circuit Diagnosis / B1427 Config Setting

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC Detection Condition
B1427-55

ECU SETTING

(Electronic control unit setting)
Diagnosis condition When ignition switch is ON.
Signal (terminal)
Threshold When no data is stored in the air bag diagnosis sensor unit.
Diagnosis delay time 1 second or more.

POSSIBLE CAUSE

  • Mistake of configuration of air bag diagnosis sensor unit

  • Incomplete configuration of air bag diagnosis sensor unit

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

CHECK SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “AIR BAG”.

Is malfunctioning part detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

PERFORM CONFIGURATION

Perform configuration for air bag diagnosis sensor unit.

>>

Refer to Work Procedure.

    B1426 Disposal Deployment Detection

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B1426-00 AIRBAG DISPOSAL DETECT Diagnosis condition When ignition switch is ON...

    B142x Collision Detection

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B1421-00 FRONTAL COLLISION Diagnosis condition When ignition switch is ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis System (sonar Control Unit)


    CONSULT Function CAUTION: After disconnecting the CONSULT vehicle interface (VI) from the data link connector, the ignition must be cycled OFF → ON (for at least 5 seconds) → OFF. If this step is not performed, the BCM may not go to ”sleep mode”, potentially causing a discharged battery and no-start condition...

    Nissan Murano (Z52) 2015-2024 Service Manual: High-Pressure Pipe


    Removal and Installation REMOVALDischarge the refrigerant. Refer to Recycle Refrigerant. Remove the power steering oil pump assembly. Refer to Removal and Installation. Remove the washer tank. Refer to Removal and Installation. Remove bolt (A) and disconnect the internal heat exchanger (1) from the high-pressure pipe (3)...

    Categories

    Front manual seat adjustment (if so equipped)

    Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.

    Forward and backward

    Nissan Murano. Front manual seat adjustment (if so equipped)

    read more

     
    Copyright © 2026 www.nimurano.com