Nissan Murano: Restraints / Srs Air Bag Control System :: System Description

Nissan Murano (Z52) 2015-2024 Service Manual / Restraints / Srs Air Bag Control System :: System Description

Srs Air Bag Control System :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Component Parts. Srs Air Bag Control System

Component Parts Location A. Left side of roof line (view with headliner removed) B. Right of rear passenger seat (view with rear wheel house finisher removed) C...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0112 Iat Sensor


DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0112 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0113 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0112 Harness and connectors (The sensor circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: Ldw


O..

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com