Nissan Murano: Srs Air Bag Control System :: Symptom Diagnosis / Srs Air Bag Warning Lamp Does Not Turn on
CHECK METER FUSE
Check the 5A fuse [No. 31, located in the fuse block (J/B)].
Is the fuse blown?
YES>>GO TO 2.
NO>>GO TO 3.
REPLACE METER FUSE AND CHECK AGAIN
Replace 5A fuse [No. 31, located in the fuse block (J/B)] and place ignition switch in the ON position.
Does the fuse blow again?
YES>>Replace fuse and harness.
NO>>Inspection End.
CHECK HARNESS CONNECTIONS BETWEEN AIR BAG DIAGNOSIS SENSOR UNIT AND COMBINATION METER
Inspect the harness and connectors between the air bag diagnosis sensor unit and the combination meter.
Do the harness or connectors have any visible damage?
YES>>Replace harness.
NO>>GO TO 4.
CHECK COMBINATION METER
Disconnect the air bag diagnosis sensor unit harness connectors and place ignition switch in the ON position.
Does air bag warning lamp turn on?
YES>>Replace the air bag diagnosis sensor unit. Refer to Removal and Installation.
NO>>Replace the combination meter. Refer to Removal and Installation.
Srs Air Bag Warning Lamp Does Not Turn Off
Air Bag Warning Lamp Does Not Turn Off
CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed?
YES>>
Refer to For Frontal Collision or For Side and Rollover Collision...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Fuel Pump Control Module (fpcm)
System Description SYSTEM DIAGRAM*1: ECM determines the start signal status by the signals of engine speed and battery voltage.*2: This sensor is not used to control the engine system under normal conditions.INPUT/OUTPUT SIGNAL CHART Sensor Input signal to ECM ECM function Actuator Crankshaft position sensor (POS) Engine speed* Fuel pump control FPCM ↓ Fuel pump Camshaft position sensor (PHASE) Engine coolant temperature sensor Engine coolant temperature Mass air flow sensor Amount of intake air Battery Battery voltage* *: ECM determines the start signal status by the signals of engine speed and battery voltage...
Nissan Murano (Z52) 2015-2024 Service Manual: Normal Operating Condition
Description RELATED TO NOISEThe majority of the audio concerns are the result of outside causes (bad CD, electromagnetic interference, etc.).The following noise results from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and other sources...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Vehicle Dynamic Control (VDC) OFF switch
- Memory storage function (key-link)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
