Nissan Murano: Srs Air Bag Control System :: Dtc/circuit Diagnosis / U1000 Can Comm Circuit
DESCRIPTION
CAN (Controller Area Network) is a serial communication system for real-time application. It is an on-Nissan Murano vehicle multiplex communication system with high data communication speed and excellent error detection ability. Many electronic control units are equipped into Nissan Murano vehicles, and each control unit shares information and links with other control units during operation. With CAN communication, control units are connected with two communication lines (CAN-High line, CAN-Low line), allowing a high rate of information transmission with less wiring. Each control unit transmits and receives data but selectively reads required data only. Refer to CAN Communication Signal Chart.
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC detecting condition | |
|---|---|---|---|
| U1000-01 | CAN COMM CIRCUIT | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
—
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
-
Ignition switch ON and wait for 7 seconds or more.
-
Select “Self Diagnostic Result” mode of “AIR BAG”.
-
Check if any DTC is displayed in the “Self Diagnostic Result”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Refer to Intermittent Incident.
CHECK CAN COMMUNICATION SYSTEM
Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.
>>
Inspection End.
U1010 Control Unit(can)
DTC Description
DESCRIPTIONAir bag diagnosis sensor unit performs self-tests at ignition switch ON. If CAN communication failure within control unit is detected, DTC is set...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Power Supply and Ground Circuit. Distance Sensor (icc Sensor)
Diagnosis Procedure CHECK FUSES Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 29 (10A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2...
Nissan Murano (Z52) 2015-2024 Owners Manual: Conditions the Remote Engine Start will notwork
The Remote Engine Start will not operate if any of the following conditions are present: The ignition switch is placed in the ON position. The hood is not securely closed. The hazard indicator lights are on. The engine is still running. The engine must be completely stopped...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- All-Wheel Drive (AWD) (if so equipped)
- How to enable/disable the LDW system
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
