Nissan Murano: Srs Air Bag Control System :: Symptom Diagnosis / Seat Belt Indctr Lamp Is On, Pass Air Bag Indctr Is on or Off
Diagnosis Procedure
Vehicle conditions:
-
Seat belt indicator lamp is ON, passenger air bag indicator lamp is ON or OFF.
-
Passenger seat is unoccupied.
-
Driver seat belt is buckled.
-
Front seat belt buckle switch RH harness and front seat belt buckle switch RH are OK (buckle passenger seat belt to check if seat belt indicator lamp turns OFF, driver seat belt needs to be buckled).
REPLACE OCS SENSORS
-
Replace the OCS sensors. Refer to Removal and Installation.
-
Perform zero point reset. Refer to Description.
Is symptom still present?
YES>>
GO TO 2.
NO>>
Inspection End.
REPLACE PASSENGER SEAT CUSHION FRAME
-
Replace the passenger seat cushion frame. Refer to Seat Cushion.
-
Perform zero point reset. Refer to Description.
>>
Inspection End.
Diagnosis Procedure
SRS air bag warning lamp is OFF, passenger air bag indicator lamp turns ON intermittently with a person of adult stature seated normally in the passenger seat...
Other information:
Description
CAUTION:
Always perform the decel G sensor calibration before driving when the following operation is performed:
NOTE:
Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.
×: Required —: Not required Procedure Decel G sensor calibration
Removing/ installing ABS actuator and electric unit (control unit)
—
Replacing ABS actuator and electric unit (control unit)
×
Removing/installing steering components
—
Replacing steering components
×
Removing/installing suspension components
—
Replacing suspension components
×
Removing/installing tire
—
Replacing tire
×
Tire rotation
—
Adjusting wheel alignment
×
Work Procedure
Decel G sensor calibrationCAUTION:
Always use CONSULT for the decel G sensor calibration...
System Description
SYSTEM DIAGRAMSystem DescriptionThe occupant classification system (OCS) identifies different size occupants, out of position occupants, and detects if a child seat is present in the front passenger seat. The OCS control unit (2) receives inputs from the occupant classification system sensors (1) (located inside the passenger seat cushion assembly)...