Nissan Murano: Srs Air Bag :: Removal and Installation / Front Seat Belt Buckle Switch
Removal and Installation
The front seat belt buckle switch is part of the front seat belt buckle. For removal and installation of the front seat belt buckle, refer to Removal and Installation.
Removal and Installation
For removal and installation procedures, refer to Removal and Installation (Front seat belt) or Removal and Installation (Second row seat belt)...
Removal and Installation
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNITWARNING:
Before servicing SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
C1601
BATTERY VOLT
(Battery voltage)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
Power steering control module supply voltage (terminals 1 and 5)
Threshold
Less than 8 V or more than 19 V
Diagnosis delay time
Less than 1 second
POSSIBLE CAUSE
Harness or connectors
Power steering control module
Fuse
Battery power supply circuit
Battery
FAIL-SAFEManual steering state
DTC Confirmation Procedure
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...
System Description
DESCRIPTIONPower seat can be operated only with ignition ON or during retained power operation.Sliding OperationWhile operating the sliding switch located in power seat switch, the sliding motor operates and makes the seat front and back position adjustment possible...