Nissan Murano: Srs Air Bag :: Removal and Installation / Rear Side Air Bag Module
The rear side air bag module is part of the second row seatback. For unit disassembly and assembly of the second row seat, refer to Seatback (LH) or Seatback (RH).
Front Side Air Bag Module
Removal and Installation
The front side air bag module is part of the front seatback. For removal and installation of the front seatback, refer to Seatback...
Crash Zone Sensor
Exploded View
1.
Crash zone sensor
A.
Crash zone sensor harness connector
Removal and Installation
WARNING:
Before servicing SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Low-Pressure Flexible Hose
Removal and Installation REMOVALDischarge the refrigerant. Refer to Recycle Refrigerant. Remove the front under cover. Refer to Exploded View. Remove the low-pressure flexible hose bolt from the internal heat exchanger. CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air...
Nissan Murano (Z52) 2015-2024 Service Manual: C1734 Control Unit
DTC Description NOTE: The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTCs Register TPMS sensor IDs DTC DETECTION LOGIC DTC No...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- GAS STATION INFORMATION
- Memory storage function (key-link)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
