Symptom Description
The AEB warning lamp is blinking. Refer to Diagnosis Procedure.NOTE:
When any of the following conditions, the AEB warning lamp blinks:
The distance sensor area of the front of the Nissan Murano vehicle is covered with dirt or is obstructed
The interior temperature of the vehicle is extremely high
The windshield is dirty, frosted, fogged up, or damaged in front of the lane camera unit
The lane camera unit or the lane camera unit bracket is not mounted properly
Diagnosis Procedure
CHECK THE WINDSHIELD
Check if the windshield is dirty, frosted, fogged up, or damaged in front of the lane camera unit...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Other information:
Removal and Installation
WARNING:
Situate the vehicle on a flat and solid surface.
Place chocks at front and back of rear wheels.
CAUTION:
Always work safely.
Do not start work until the engine and exhaust system are cooled completely.
Refer to the applicable sections for warnings, cautions, notes, and instructions if necessary procedures are not included in this section...
Component Function Check
CHECK FUNCTION
CONSULT
Select “RKE OPE COUN1” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”.
Check that the function operates normally according to the following conditions:
Monitor Item Condition
RKE OPE COUN1
Checks whether value changes when operating Intelligent Key...