Nissan Murano: Steering Control System :: Symptom Diagnosis / Hydraulic Pump Electric Power Steering Warning Lamp Does Not Turn Off
Hydraulic pump electric power steering warning lamp does not turn OFF several seconds after engine is started.
SELF DIAGNOSTIC RESULT
CONSULT
Select "Self Diagnostic Result" mode of "EPS/DAST 3".
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 2.
CHECK HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP
Perform the trouble diagnosis of hydraulic pump electric power steering warning lamp. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning components.
POWER STEERING CONTROL MODULE POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis of power steering control module power supply and ground. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Check that the pin terminals and the connection of each connector are normal.
NO>>Repair or replace the malfunctioning components.
Hydraulic Pump Electric Power Steering Warning Lamp Does Not Turn on
Diagnosis Procedure
The hydraulic pump electric power steering warning lamp does not illuminate when ignition switch ON (lamp check).CHECK THE HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP
Perform trouble diagnosis for the hydraulic pump electric power steering warning lamp system...
Steering Wheel Turning Force Is Heavy or Light
Diagnosis Procedure
SELF DIAGNOSTIC RESULT
CONSULT
Select "Self Diagnostic Result" mode of "EPS/DAST 3".
Is a malfunctioning system displayed?
YES>>
Check malfunctioning system...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: B210d Starter Rly on Circ
DTC Description Located in IPDM E/R, the starter relay runs the starter motor. The starter relay is turned ON by the BCM when ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.DTC DETECTION LOGICNOTE: If DTC B210D is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000...
Nissan Murano (Z52) 2015-2024 Owners Manual: Canceling a Remote Engine Start
To cancel a Remote Engine Start, perform one of the following: Aim the Intelligent Key at the vehicle and press until the parking lights turn off. Turn on the hazard warning flashers. Cycle the ignition switch on and then off. The extended engine run time has expired...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- Intelligent Forward Collision Warning (I-FCW)
- Rear bench seat adjustment
- New on site
- Most important about car
Unfastening the seat belts. Checking seat belt operation
Unfastening the seat belts
To unfasten the seat belt, press the button
on the buckle 
. The seat belt
automatically
retracts.
