Nissan Murano: Steering Control System :: Symptom Diagnosis / Hydraulic Pump Electric Power Steering Warning Lamp Does Not Turn on
Diagnosis Procedure
The hydraulic pump electric power steering warning lamp does not illuminate when ignition switch ON (lamp check).
CHECK THE HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP
Perform trouble diagnosis for the hydraulic pump electric power steering warning lamp system. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
Check that the pin terminals and the connection of each connector are normal.
NO>>
Repair or replace the malfunctioning components.
Diagnosis Procedure
Hydraulic pump electric power steering warning lamp does not turn OFF several seconds after engine is started.SELF DIAGNOSTIC RESULT
CONSULT
Select "Self Diagnostic Result" mode of "EPS/DAST 3"...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1315–13
AM/FM 1 antenna
(Radio antenna)
[OPEN]
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
ANT +B circuit between AV control unit and antenna base (terminal 67)
Threshold
–
Diagnosis delay time
30 seconds or more
B1315–11
[GND–SHORT]
Diagnosis condition
When ignition switch is ON...
Component Parts Location
A.
RH front of engine compartment
B.
View with front fascia removed from Nissan Murano vehicle
No. Component Function
1.
IPDM E/R (Intelligent Power Distribution Module Engine Room)
A/C relay is integrated in IPDM E/R...