Nissan Murano: Steering System :: Removal and Installation / Power Steering Oil Pump
| 1. | Power steering reservoir cap | 2. | Power steering oil pump | 3. | Low-pressure piping |
| 4. | High-pressure piping |  |
Front |
WARNING:
Power steering pump outer shell will be hot while running and after driving. When working, be sure to wear protective equipment to avoid getting burned.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
REMOVAL
Remove the cover. Refer to Exploded View.
Drain power steering fluid. Refer to Draining and Refilling.
Disconnect the harness connectors (A) from the power steering oil pump.
Remove the harness retainer from the power steering oil pump bracket.
Remove the line retaining bolt from bracket.
Separate the-high pressure piping (2) and low-pressure piping (1) from the power steering oil pump.
Separate the clips from the power steering oil pump.
: Clip
Remove nut and bolts and remove the power steering oil pump.
INSTALLATION
Installation is in the reverse order of removal.
-
Bleed air from power steering system. Refer to Air Bleeding Hydraulic System.
CAUTION:
Do not reuse O-rings.
Steering Gear and Linkage
Exploded View
1.
Outer socket
2.
Inner socket lock nut
3.
Small boot clamp
4.
Boot
5.
Large boot clamp
6.
Inner socket
7.
Spacer
8...
Hydraulic Line
Exploded View
FWD 1.
Power steering oil pump
2.
Cover
3.
High-pressure piping
4.
Steering gear
5.
Low-pressure piping (lower)
6.
Low-pressure piping (upper)
Clip
Front
NOTE:
Service high-pressure and low-pressure piping as an assembly of hydraulic lines...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance
The two radar sensors for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the radar sensors...
Nissan Murano (Z52) 2015-2024 Owners Manual: Before starting the engine
Make sure the area around the vehicle is clear. Check fluid levels such as engine oil, coolant, brake fluid, and windshieldwasher fluid as frequently as possible, or at least whenever you refuel. Check that all windows and lights are clean...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- GAS STATION INFORMATION
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward
