Nissan Murano: Steering System :: Basic Inspection / Steering Gear and Linkage

Nissan Murano (Z52) 2015-2024 Service Manual / Steering / Steering System :: Basic Inspection / Steering Gear and Linkage

Inspection

BOOT

Check boot for cracks. Replace if any damage is found.

OUTER SOCKET AND INNER SOCKET

Ball joint swinging torque
- Hook the Tool at the measuring point and pull the Tool. Make sure that the Tool reads the specified value when ball stud and inner socket start to move. Replace outer socket or inner socket if measured values are outside the standard.
  
  Measuring point of outer socket (1) : Ball stud upper side (A)
  
  Measuring point of inner socket (2) : Point (B) as shown
  
  Tool number : — (J-44372)
  
  Swinging torque : Refer to Steering Gear.
Ball joint rotating torque
- Make sure that the reading is within the following specified range using suitable tool (A). Replace outer socket if the reading is outside the specification.
  
  Rotating torque : Refer to Steering Gear.
Ball joint axial end play
- Apply an axial load of 490 N (50 kg, 111 lb) to ball stud. Measuring the amount of stud movement using a suitable tool, make sure that the value is within specification. Replace outer socket (1) or inner socket (2) if the measured value is outside specification.
  
  Axial end play : Refer to Steering Gear.

Power Steering Oil Pump

Inspection Connect the Tool between power steering oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully...

Steering System :: Dtc/circuit Diagnosis

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0222 Tp Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the TP sensor 1 is sent to ECM. An excessively high voltage from the TP sensor 1 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0222 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively low voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — P0223 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively high voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0222 Harness or connectors (TP sensor 1 circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: U0104-00 Adas Can 1

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0104-00 ADAS CAN CIRC 1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON. Signal (terminal) - Threshold If lane camera unit detects an error signal that is received from ADAS control unit via ITS communication...