Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Dtc/circuit Diagnosis
Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Dtc/circuit Diagnosis
- U1000 Can Comm Circuit
- U1010 Control Unit(can)
- B2401 Ign Open
- B2409 Half Latch Sw
- B2416 Touch Sen R Open
- B2422 Back Door State
- B2423 Abd Mtr Time Out
- B2426 Spindle Sensor Lh
- B242a Clsr Condition
- B242b Detect Sensor Power Supply
- B242e Hands Free Sensor 2
- B242f Abd Buzzer
- B261b Res Eng Run Stuck Malfunc
- B2622 Inside Antenna
- B26fd Shft Lck Slnoid Insid F/b Mlfnc
- B26fe Hood Sw Can Diag Error
- B26ff Intelligent Tuner Comm Err
- B2626 Outside Antenna
- U1320 Reprogramming
- Power Supply and Ground Circuit. Automatic Back Door Control Module
- Door Switch
- Back Door Switch
- Door Lock and Unlock Switch. Driver Side
- Door Lock Actuator. Front Lh
- Unlock Sensor
- Remote Keyless Entry Receiver
- Door Request Switch
- Back Door Request Switch
- Intelligent Key Warning Buzzer
- Intelligent Key
- Meter Buzzer Circuit
- Key Warning Lamp
- Half Switch
- Touch Sensor. Rh
- Spindle Motor. Rh
- Back Door Closure Motor
- Automatic Back Door Warning Buzzer
- Hood Switch
- Integrated Homelink Transceiver
Calibration of Automatic Back Door Position Information
Description
When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system:
After removing and installing or replacing back door assembly
After removing and installing or replacing spindle unit
After adjustment or position change of the back door hinges or striker
Work Procedure
STEP 1
Fully close the back door manually...
U1000 Can Comm Circuit
DTC Description
CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Sunshade Motor Assembly
Removal and Installation REMOVALRemove the headlining. Refer to Removal and Installation. Disconnect the harness connector (A) from the sunshade motor assembly (1). Remove sunshade motor assembly screws (B). Remove the sunshade motor assembly from the moonroof unit assembly (2)...
Nissan Murano (Z52) 2015-2024 Service Manual: Meter, Warning Lamp & Indicator :: Preparation. Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools (TechMate No...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Vehicle Dynamic Control (VDC) OFF switch
- Fuel recommendation
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.
Copyright © 2026 www.nimurano.com