Nissan Murano: Door & Lock :: Dtc/circuit Diagnosis / Meter Buzzer Circuit
-
The buzzer for the warning chime system is installed in the combination meter.
-
The combination meter sounds the buzzer based on the signals transmitted from various units.
CHECK OPERATION OF METER BUZZER
CONSULT
Select “LIGHT WARN ALM” or “SEAT BELT WARN TEST” of “Active Test” mode of “BCM(BUZZER)”.
Does meter buzzer activate?
YES>>Inspection End.
NO>>Refer to Diagnosis Procedure.
CHECK COMBINATION METER INPUT SIGNAL
CONSULT
Select “BUZZER” in “Data Monitor” mode of “METER/M&A”.
| BUZZER | Status |
| Under the condition of buzzer input | On |
| Except above | Off |
Is the inspection result normal?
YES>>Replace combination meter. Refer to Removal and Installation.
NO>>Replace BCM. Refer to Removal and Installation.
Intelligent Key
Component Function Check
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information...
Key Warning Lamp
Component Function Check
CHECK FUNCTION
CONSULT
Select “INDICATOR” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.
Select “KEY IND” or “KEY ON” to check that it works normally...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Precautions
Description Observe the following precautions to ensure safe and proper servicing. These precautions are not described in each individual section. Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Nissan Murano (Z52) 2015-2024 Service Manual: U1507-87 Lost Comm (side Rdr R)
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition U1507-87 LOST COMM(SIDE RDR R) [Lost communication (Side radar right)] Diagnosis condition When engine is running When Blind Spot Warning system is ON Signal (terminal) ITS communication signal Threshold ADAS control unit cannot receive ITS communication signal from side radar RH Diagnosis delay time 2 seconds or more POSSIBLE CAUSE Side radar RH right/left switching signal circuit ITS communication system Side radar RH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Confirmation Procedure DTC CONFIRMATION PROCEDURECHECK DTC PRIORITY If DTC “U1507-87” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Shift lock release
- All-Wheel Drive (AWD) (if so equipped)
- Power Steering Fluid (PSF)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
