Nissan Murano: Door & Lock :: Basic Inspection / Calibration of Automatic Back Door Position Information

Description

When the following work is performed, it is necessary to perform initial setting of automatic back door position information to operate automatic back door system:

• After removing and installing or replacing back door assembly

• After removing and installing or replacing spindle unit

• After adjustment or position change of the back door hinges or striker

STEP 1

Fully close the back door manually.

GO TO 2.

STEP 2

CONSULT

1. Select “RESET AUTO BACK DOOR STATUS” in “Work support” mode of “AUTO BACK DOOR”.

2. Select “START” to erase automatic back door position information.

GO TO 3.

STEP 3

Operate back door opener switch and perform automatic open operation.

NOTE:

At this time, automatic operation of back door is performed at half speed.

GO TO 4.

STEP 4

1. The back door fully opens.

2. Check that automatic back door warning buzzer sounds normally.

Do automatic back door warning buzzer sound normally?

GO TO 5.

GO TO 1.

STEP 5

Fully close the back door.

Inspection End.