Nissan Murano: Door & Lock :: Dtc/circuit Diagnosis / Key Warning Lamp
Component Function Check
CHECK FUNCTION
CONSULT
-
Select “INDICATOR” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.
-
Select “KEY IND” or “KEY ON” to check that it works normally.
Is the inspection result normal?
YES>>
Key warning lamp is OK.
NO>>
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK KEY WARNING LAMP
Refer to CONSULT Function (METER/M&A).
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>
Inspection End.
Description
The buzzer for the warning chime system is installed in the combination meter.
The combination meter sounds the buzzer based on the signals transmitted from various units...
Component Function Check
CHECK FUNCTION
CONSULT
Select “HALF LATCH SW” in “Data Monitor” mode of “AUTO BACK DOOR”.
Check that the function operates normally according to the following conditions:
Monitor Item Condition Status
HALF LATCH SW
Back door
Open/fully closed
OFF
Half latch
ON
Is the inspection result normal?
YES>>
Half latch switch is OK...
Other information:
The lane camera unit for the LDW
system
is located above the inside mirror. To
keep the proper operation of the LDW system
and prevent a system malfunction, be
sure to observe the following:
Always keep the windshield clean.
Do not attach a sticker (including transparent
material) or install an accessory
near the camera unit...
Diagnosis Procedure
PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to Special Repair Requirement.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Perform basic inspection. Refer to Work Flow.
RETEST THE ANTI-PINCH FUNCTION
Check anti-pinch operation...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more