Nissan Murano: Dtc/circuit Diagnosis / B130c Tcu Pairing Error
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B130C |
TCU pairing error (TCU pairing error) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
TCU-BCM pairing during Intelligent Key registration.
-
TCU
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC B130C detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
RE-REGISTER INTELLIGENT KEYS
Re-register all Intelligent Keys. For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.
>>
GO TO 2.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
-
Erase “Self Diagnostic Result” mode of “TELEMATICS”.
-
Ignition switch OFF → ON.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC B130C detected?
YES>>Replace the TCU. Refer to Removal and Installation.
NO>>Inspection End.
B130d Tel Line Out Error
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B130D
TEL LINE OUT ERROR
(Telephone line out error)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Wheel Alignment
Inspection PRELIMINARY INSPECTIONWARNING: Always adjust wheel alignment with vehicle on a flat surface. NOTE: If wheel alignment is out of specification, inspect and replace any damaged or worn suspension parts before making any adjustments. Check the following: Check and adjust wheel alignment with vehicle under unladen conditions...
Nissan Murano (Z52) 2015-2024 Service Manual: System Initialization
Description Always perform the initialization when the battery terminal is disconnected or the driver seat control unit is replaced.The entry/exit assist function will not operate normally if no initialization is performed. Work Procedure INITIALIZATION PROCEDURECHOOSE METHOD There are two initialization methods...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Settings
- Turning the AEB system on/off
- GAS STATION INFORMATION
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.