Nissan Murano: Door & Lock :: Dtc/circuit Diagnosis / B2423 Abd Mtr Time Out

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Dtc/circuit Diagnosis / B2423 Abd Mtr Time Out

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen items (Trouble diagnosis content)	DTC detecting condition
B2423	ABD MTR TIME OUT (Automatic back door motor time out)	Diagnosis condition	When the automatic back door is operated approximately 5-6 times (open & close cycles) continuously (for 60–100 seconds in any direction) without any stoppages, the control module will momentarily inhibit operation to protect the system.
		Signal (terminal)	–
		Threshold	–
		Diagnosis delay time	–

POSSIBLE CAUSE

Normal operation
Automatic back door control module

FAIL-SAFE

Inhibit automatic back door system all function

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

Ignition switch ON.
Operate automatic back door.
Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

ERASE DTC

CONSULT

At least 180 seconds are passed after automatic back door operation is inhibited.
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AUTO BACK DOOR”.
Erase DTC, and then repeat “DTC CONFIRMATION PROCEDURE”. Refer to DTC Confirmation Procedure.

Is DTC detected?

YES>>

Replace automatic back door control module. Refer to Removal and Installation.

NO>>

Inspection End.

B2422 Back Door State

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2422–78 BACK DOOR STATE (Back door state) Diagnosis condition All times Signal (terminal) Encoder LH A signal, encoder LH B signal, encoder RH A signal, encoder RH B signal (automatic back door control module connector terminal: 19, 20, 21) Threshold When the automatic back door control module detect the encoder pulse signal LH does not according with the encoder pulse signal RH Diagnosis delay time – B2422–79 BACK DOOR STATE (Back door state) Diagnosis condition All times Signal (terminal) – Threshold When automatic back door position information is deleted from automatic back door control module memory Diagnosis delay time – POSSIBLE CAUSE Improper installation of back door assembly Calibration of automatic back door position information Back door mechanism Encoder Harness or connectors (encoder circuit is open or shorted) Automatic back door control module Battery terminal is disconnected and reconnected FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

B2426 Spindle Sensor Lh

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2426–11 SPINDLE SENSOR LH (Spindle sensor left hand) Diagnosis condition All times Signal (terminal) Encoder LH power supply (automatic back door control module connector terminal: 19) Threshold Short circuit is detected in encoder power supply output circuit inside automatic back door control module...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0531 Refrigerant Pressure Sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0531 REFRIGERANT PRESS SENSOR A (A/C refrigerant pressure sensor A circuit range/performance) Diagnosis condition Ignition switch ON Engine running Signal (terminal) Refrigerant pressure sensor signal Threshold ECM detects that input signal is out of the specified range...

Nissan Murano (Z52) 2015-2024 Owners Manual: Tire inflation pressure

Check the tire pressures (including the spare) often and always prior to long distance trips. The recommended tire pressure specifications are shown on the F.M.V.S.S./C.M.V.S.S. certification label or the Tire and Loading Information label under the “Cold Tire Pressure” heading...