Nissan Murano: System Description / Diagnosis System (bcm)
Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / System Description / Diagnosis System (bcm)
- Common Item
- Door Lock
- Rear Defogger
- Buzzer
- Int Lamp
- Head Lamp
- Wiper
- Flasher
- Air Conditioner
- Intelligent Key
- Comb Sw
- Bcm
- Immu
- Battery Saver
- Trunk
- Theft Alm
- Retained Pwr
- Signal Buffer
- Air Pressure Monitor
Shipping Mode Control System
System Description
SYSTEM DIAGRAMSignal transmission function list Signal name Input Output Description
Shipping mode status signal
BCM
Combination meter (CAN)
Transmits shipping mode status signal to combination meter when condition is established...
Common Item
CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEMCONSULT performs the following functions via CAN communication with BCM: Direct Diagnostic Mode Description
ECU Identification
The BCM part number is displayed...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0890 Tcm
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0890 TCM (Transmission Control Module Power Relay Sense Circuit Low) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Battery voltage: Less than 8...
Nissan Murano (Z52) 2015-2024 Service Manual: P0196 Eot Sensor
DTC Description DTC DETECTION LOGIC Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signals from EOT sensor and intake air temperature sensor. The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the signal voltage of the EOT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- All-Wheel Drive (AWD) (if so equipped)
- Fuel recommendation
- Vehicle Dynamic Control (VDC) OFF switch
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
Copyright © 2026 www.nimurano.com