Nissan Murano: Diagnosis System (bcm) / Bcm

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / System Description / Diagnosis System (bcm) / Bcm

CONSULT Function (BCM - BCM)

ECU IDENTIFICATION

The BCM part number is displayed.

SELF DIAGNOSTIC RESULT

Refer to DTC Index.

WORK SUPPORT

Support Item	Setting	Description
RESET SETTING VALUE	Reset	Returns BCM to initial value in factory shipment.
RESET SETTING VALUE	Cancel	Cancels the reset function.
BCM diagnosis when engine does not start	—	This function allows engine start function self-diagnosis.
BCM diagnosis when the door lock is malfunctioning	—	This function allows door lock function self-diagnosis.
Diagnosis for remote engine starter	—	This function allows remote engine starter function self-diagnosis.

CONFIGURATION

Refer to Description.

CAN DIAG SUPPORT MNTR

Refer to CAN Diagnostic Support Monitor.

Comb Sw

CONSULT Function (BCM - COMB SW) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description FR WIPER HI [On/Off] Indicates condition of wiper operation of combination switch...

Immu

CONSULT Function (BCM - IMMU) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description CONFRM ID ALL [Yet/DONE] Switches to DONE when an Intelligent Key is registered...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Hood Switch

Component Function Check CHECK FUNCTION CONSULT Select “HOOD SW” and “HOOD SW 2” in “Data Monitor” mode of “IPDM E/R”. Check “HOOD SW” and “HOOD SW 2” indication under the following condition: Monitor item Condition Indication HOOD SW Hood Open OFF Close ON HOOD SW 2 Open ON Close OFF Is the indication normal? YES>> Hood switch is OK...

Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Touch Sensor

Removal and Installation CAUTION: Use care not to bend touch sensor. Replace the back door touch sensor if it has been dropped or sustained an impact. REMOVALRelease touch sensor clips using a suitable tool. Disconnect the harness connector from the touch sensor and remove...