Nissan Murano: Diagnosis System (bcm) / Rear Defogger

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / System Description / Diagnosis System (bcm) / Rear Defogger

CONSULT Function (BCM - REAR DEFOGGER)

ECU IDENTIFICATION

The BCM part number is displayed.

SELF DIAGNOSTIC RESULT

Refer to DTC Index.

DATA MONITOR

Monitor Item [Unit]	Description
PUSH SW [On/Off]	Indicates condition of push-button ignition switch.
REAR DEF SW [On/Off]	Indicates condition of rear window defogger switch.

ACTIVE TEST

Test Item	Description
REAR DEFOGGER	This test is able to check rear window defogger operation [Off/On].

WORK SUPPORT

Support Item	Setting	Description
SET R-DEF TIMER	MODE3	Rear defogger turns OFF after 1 minute.
	MODE2	Rear defogger remains ON until turned OFF.
	MODE1*	Rear defogger turns OFF after 15 minutes.

*: Initial setting

Door Lock

CONSULT Function (BCM - DOOR LOCK) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description REQ SW-DR [On/Off] Indicates condition of door request switch LH...

Buzzer

CONSULT Function (BCM - BUZZER) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description PUSH SW [On/Off] Indicates condition of push-button ignition switch...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Cvt Fluid

Inspection FLUID LEAKAGE Check transaxle surrounding area (oil seal and plug etc.) for fluid leakage. If transaxle appears to have oil seepage or a leak, follow the steps below to assist in a correct diagnosis. Thoroughly clean off the area of the suspected leak...

Nissan Murano (Z52) 2015-2024 Service Manual: P1212 Tcs Communication Line

DTC Description DESCRIPTIONThis CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and “ABS actuator and electric unit (control unit)”.Be sure to erase the malfunction information such as DTC not only for “ABS actuator and electric unit (control unit)” but also for ECM after TCS related repair...