Nissan Murano: Diagnosis System (bcm) / Air Conditioner

Flasher

CONSULT Function (BCM - FLASHER) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description REQ SW -DR [On/Off] Indicates condition of door request switch LH...

Intelligent Key

CONSULT Function (BCM - INTELLIGENT KEY) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Main Description REQ SW -DR [On/Off] × Indicates condition of door request switch LH...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2100 Throttle Control Motor Relay

DTC Description DTC DETECTION LOGIC ECM detects that the voltage of power source for throttle control motor is excessively low. ECM detects that the throttle control motor relay is stuck ON. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2100 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit/open) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects that the voltage of power source for throttle control motor is excessively low Diagnosis delay time — P2103 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit high) Diagnosis condition Ignition switch ON Signal (terminal) Throttle control motor circuit Threshold ECM detects that the throttle control motor relay is stuck ON Diagnosis delay time — POSSIBLE CAUSEDTC P2100 Harness or connectors (Throttle control motor relay circuit is open) Throttle control motor relay DTC P2103 Harness or connectors (Throttle control motor relay circuit is shorted) Throttle control motor relay FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Throttle control motor relay ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx...

Nissan Murano (Z52) 2015-2024 Service Manual: Blower Unit

Exploded View 1. Blower unit 2. Heating and cooling unit Front Removal and Installation REMOVALRemove the heating and cooling unit assembly. Refer to Removal and Installation. Disconnect the harness connector from the blower motor. Remove the screw and then the blower unit from the heating and cooling unit assembly...