Nissan Murano: System / Shipping Mode Control System
System Description
SYSTEM DIAGRAM

Signal transmission function list
| Signal name | Input | Output | Description |
| Shipping mode status signal |
BCM |
Combination meter (CAN) |
Transmits shipping mode status signal to combination meter when condition is established. |
DESCRIPTION
-
The BCM switches the status (shipping mode or normal mode) by itself according to the extended storage switch condition, and transmits the shipping mode status signal to the combination meter and each unit via CAN communication.
-
When the shipping mode function is activated, the control units will not detect DTCs.
-
BCM control functions are limited in shipping mode. Refer to Description.
-
When the BCM is in shipping mode, a message may be shown in the combination meter or display.
-
For shipping mode cancel operation, refer to Work Procedure.
System Description
SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNALMajor signal transmission between each unit via communication lines is shown in the following table: Component parts Signal description
IPDM E/R
Each unit transmits the sleep-ready signal (ready) to BCM when all of the CAN sleep conditions are fulfilled...
Other information:
WARNING
Listed below are the system limitations
for MOD. Failure to operate the vehicle
in accordance with these system limitations
could result in serious injury or
death.
Do not use the MOD system when
towing a trailer. The system may not
function properly...
Diagnosis Procedure
CHECK MODE DOOR MOTOR POWER SUPPLY
Ignition switch ON.
Check voltage between mode door motor harness connector and ground.
+ −
Voltage
(Approx.)
Mode door motor
Connector Terminal
M154
1
Ground
Battery voltage
Is the inspection result normal?
YES>>
GO TO 2...