Nissan Murano: Diagnosis System (bcm) / Trunk

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / System Description / Diagnosis System (bcm) / Trunk

CONSULT Function (BCM - TRUNK)

ECU IDENTIFICATION

The BCM part number is displayed.

SELF DIAGNOSTIC RESULT

Refer to DTC Index.

DATA MONITOR

Monitor Item [Unit]	Description
PUSH SW [On/Off]	Indicates condition of push-button ignition switch.
UNLK SEN -DR [On/Off]	Indicates condition of door unlock sensor.
VEH SPEED 1 [km/h]	Indicates Nissan Murano vehicle speed signal received from ABS on CAN communication line.
KEY CYL SW-TR [On/Off]	Indicates condition of the back door key cylinder switch.
TR CANCEL SW [On/Off]	Indicates condition of the trunk lid opener cancel switch.
TR/BD OPEN SW [On/Off]	Indicates condition of back door opener switch.
RKE-TR/BD [On/Off]	Indicates condition of back door open signal from Intelligent Key.
TRNK/HAT MNTR [On/Off]	Indicates condition of luggage room lamp switch.

Battery Saver

CONSULT Function (BCM - BATTERY SAVER) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description REQ SW -DR [On/Off] Indicates condition of door request switch LH...

Theft Alm

CONSULT Function (BCM - THEFT ALM) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item Description REQ SW -DR [On/Off] Indicates condition of door request switch LH...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P1572 Ascd Brake Switch

DTC Description DESCRIPTIONWhen the brake pedal is depressed, brake pedal position switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF signal).Refer to System Description for the ASCD function...

Nissan Murano (Z52) 2015-2024 Service Manual: Oil

Description MAINTENANCE OF OIL LEVELThe compressor oil is circulating in the system together with the refrigerant. It is necessary to fill compressor with oil when replacing A/C system parts or when a large amount of refrigerant leaks are detected. It is important to always maintain oil level within the specified level or the following conditions may occur: Insufficient oil amount: Stuck compressor Excessive oil amount: Insufficient cooling (caused by insufficient heat exchange) Oil Type : "Oil"...