Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Removal and Installation

Normal Operating Condition

Description If the Remote Engine Start (RES) function is inoperative, make sure the system is properly set to operate.Operating Conditions Ignition switch is OFF Shift selector is in P position Nissan Murano Vehicle security system is not in operation Hood and all doors are closed Registered Intelligent Key is not in the Nissan Murano vehicle Intelligent Key is within operating range If the RES is still not operating, refer to the table below...

Hood

..

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Front Seat Belt Buckle

Removal and Installation REMOVALRemove front seat. Refer to Removal and Installation. Disconnect seat belt buckle harness connector. Remove seat belt buckle anchor bolt and seat belt buckle. CAUTION: Before removing the seat belt buckle anchor bolt, note the positions of washers and spacers for correct installation...

Nissan Murano (Z52) 2015-2024 Service Manual: C1606 Eps Motor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1606 EPS MOTOR (EPS motor) Diagnosis condition When engine is running. Signal (terminal) — Threshold Power steering motor failure or power steering control module motor driver failure Diagnosis delay time 1 second or more POSSIBLE CAUSE Harness or connectors Power steering control motor Power steering control module FAIL-SAFEManual steering state DTC Confirmation Procedure PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test...