Nissan Murano: Door & Lock :: Removal and Installation / Remote Keyless Entry Receiver
Removal and Installation
REMOVAL
Remove glove box assembly. Refer to Removal and Installation.
Remove remote keyless entry receiver bolt.
Disconnect the harness connector from the remote keyless entry receiver.
Release pawl and remove remote key less receiver from bracket.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
CAUTION:
Replace the back door warning chime if it has been dropped or sustained an impact.
REMOVALRemove rear bumper fascia. Refer to Removal and Installation...
Removal and Installation
Release lock knob on back of Intelligent Key and remove key.
Insert a suitable tool (A) wrapped with a cloth into slit of corner and twist it to separate upper part from lower part...
Other information:
Exploded View
1.
Reinforcement plate
2.
Drive plate
3.
Rear oil seal retainer
4.
Rear oil seal
5.
Sub harness
6.
Knock sensor
7.
Cylinder block
8.
Thrust bearing (upper)
9.
Main bearing (upper)
10.
Crankshaft
11...
Component Function Check
CHECK OPERATION OF METER BUZZER
CONSULT
Select “LIGHT WARN ALM” in “Active Test” mode of “BCM(BUZZER)”.
Select “ON/OFF” to check that the function operates normally.
Is the inspection result normal?
YES>>
Inspection End...