Nissan Murano: Door & Lock :: Removal and Installation / Outside Key Antenna

Luggage Room

Removal and Installation REMOVALFold second row seatback (LH) flat. Disconnect the harness connector from the inside key antenna [luggage (1)]. Release clips (A) using a suitable tool and remove inside key antenna (luggage)...

Driver Side

Removal and Installation The driver side outside key antenna and driver side outside handle are serviced as an assembly. Refer to Removal and Installation...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: C1b52-17 Blind Spot Warning Indicator Open Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B52-17 BSW/BSI IND OPEN CIR (Blind Spot Warning indicator open circuit) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Open circuit in Blind Spot Warning indicator circuit is detected Diagnosis delay time – POSSIBLE CAUSE Blind Spot Warning indicator RH circuit Blind Spot Warning indicator RH Side radar RH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...

Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation

Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description   — (1-20-2851-1) Radar Sensor Aiming kit* Adjusting distance and radar sensors NOTE: * Tools 1–20–2721–1–IF, 1–20–2722–1–IF and J-50808 have been superseded and are no longer available, but may still be used for distance sensor alignment...