Nissan Murano: Door & Lock :: Removal and Installation / Automatic Back Door Switch

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Removal and Installation / Automatic Back Door Switch

Exploded View

1.	Upper switch carrier	2.	Middle switch carrier	3.	Heated steering wheel switch (if equipped)
4.	VDC OFF switch	5.	Automatic back door switch (if equipped)	6.	Lane intervention switch (if equipped)
7.	Mask	8.	Lower switch carrier	9.	Front power return switch (if equipped)
10.	Instrument lower panel LH	11.	Illumination control switch

Removal and Installation

REMOVAL

Remove instrument lower panel LH. Refer to Removal and Installation.

Remove screws and middle switch carrier from instrument lower panel LH.

Release pawls using a suitable tool and remove automatic back door switch from middle switch carrier.

INSTALLATION

Installation is in the reverse order of removal.

Automatic Back Door Control Module

Removal and Installation CAUTION: Replace the automatic back door control module if it has been dropped or sustained an impact. REMOVALRemove luggage side lower finisher (LH)...

Automatic Back Door Close Switch

Removal and Installation REMOVALRelease the automatic back door close switch finisher pawls using a suitable tool. Disconnect the harness connector (A) from the automatic back door close switch (1) and remove...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B0099 Satellite Sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B0099-93 SATELLITE SENSOR [RESET] [Roll Over Sensor (Subfault)] Diagnosis condition When ignition switch is ON. Signal (terminal) Satellite sensor Threshold — Diagnosis delay time — B0099-88 SATELLITE SENSOR [OPEN] [Roll Over Sensor (Subfault)] Diagnosis condition When ignition switch is ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Control Unit (bcm)

Description BEFORE REPLACEMENTWhen replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.CAUTION: When replacing the BCM, a new BCM must be used. The functions controlled by the BCM do not operate properly if a BCM from another Nissan Murano vehicle is used...