Nissan Murano: Door & Lock :: Removal and Installation / Automatic Back Door Control Module
Removal and Installation
CAUTION:
Replace the automatic back door control module if it has been dropped or sustained an impact.
REMOVAL
Remove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect the harness connectors from the automatic back door control module.
Remove nuts and automatic back door control module.
INSTALLATION
Installation is in the reverse order of removal.
Exploded View
1.
Motion activated back door bracket
2.
Motion activated back door sensor (upper)
3.
Motion activated back door sensor (lower)
4...
Exploded View
1.
Upper switch carrier
2.
Middle switch carrier
3.
Heated steering wheel switch (if equipped)
4.
VDC OFF switch
5.
Automatic back door switch (if equipped)
6...
Other information:
Diagnosis Procedure
CHECK STEERING WHEEL AUDIO CONTROL SWITCH RESISTANCE
Ignition switch OFF.
Disconnect combination switch connector.
Check resistance between the terminals of combination switch connector.
Combination switch Condition
Resistance Ω
(Approx...
Removal and Installation
REMOVALLower headlining (rear). Refer to Exploded View.
Disconnect the harness connectors from the antenna feeder.
Loosen bolt (A) and remove roof antenna (1).
INSTALLATIONInstallation is in the reverse order of removal. Roof antenna nut
: 8 N·m (0...
Categories

The autolight system allows the headlights
to turn on and off automatically. The autolight
system can:
Turn on the headlights, front parking,
tail, license plate and instrument panel
lights automatically when it is dark.
Turn off all the lights (except daylight
running lights) when it is light.
Keep all the lights on for a period of time
after you place the ignition switch in the
OFF position and all doors are closed.
read more