Nissan Murano: Door & Lock :: Removal and Installation / Inside Key Antenna
Back Door
Removal and Installation
REMOVALRemove back door outer finisher. Refer to Removal and Installation.
Disconnect the harness connector from the back door request switch...
Console
Removal and Installation
REMOVALRemove center console rear finisher. Refer to Removal and Installation.
Remove screws (A), and then remove inside key antenna [console (1)]...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0136 Ho2s2
DTC Description DTC DETECTION LOGICThe heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time...
Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Sonar System
Component Parts Location No. Component Function 1. Rear sonar sensor RH inner Refer to Sonar Sensor. 2. Rear sonar sensor RH outer 3. Around view monitor control unit (if equipped) Around view monitor control unit transmits the setting change request signal to sonar control unit via CAN communication...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- All-Wheel Drive (AWD) (if so equipped)
- Memory storage function (key-link)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
Copyright © 2026 www.nimurano.com