Nissan Murano: Door & Lock :: Removal and Installation / Rear Door Lock
Outside Handle
Removal and Installation
REMOVALFully close front door glass.
Remove front door finisher. Refer to Removal and Installation.
Remove front door vapor barrier...
Door Lock
Exploded View
1.
Outside handle escutcheon
2.
Rear gasket
3.
Outside handle bracket
4.
Outside handle
5.
Front gasket
6.
Inside door handle
7...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Roof Side Molding
Exploded View 1. Roof side molding Metal clips Removal and Installation REMOVALBeginning at the front of the vehicle, release roof side molding (1) metal clips using a suitable tool (A) then remove.: Metal clipCAUTION: Apply protective tape (B) around the roof side molding...
Nissan Murano (Z52) 2015-2024 Service Manual: Engine Coolant
System Inspection WARNING: Do not remove the radiator cap or reservoir tank cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the cooling system. When removing the radiator cap or reservoir tank cap, wrap a thick cloth around the cap and slowly turn it a quarter turn to allow built-up pressure to escape...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- System malfunction
- GAS STATION INFORMATION
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
Copyright © 2026 www.nimurano.com