Nissan Murano: Door & Lock :: Removal and Installation / Back Door Warning Chime

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Removal and Installation / Back Door Warning Chime

Removal and Installation

CAUTION:

Replace the back door warning chime if it has been dropped or sustained an impact.

REMOVAL

Remove rear bumper fascia. Refer to Removal and Installation.

Disconnect the harness connector from the back door warning chime.

Remove nuts and back door warning chime.

INSTALLATION

Installation is in the reverse order of removal.

    Intelligent Key Warning Buzzer

    Removal and Installation REMOVALRemove air cleaner and air duct. Refer to Removal and Installation. Disconnect the harness connector from the Intelligent Key warning buzzer (1)...

    Remote Keyless Entry Receiver

    Removal and Installation REMOVALRemove glove box assembly. Refer to Removal and Installation. Remove remote keyless entry receiver bolt. Disconnect the harness connector from the remote keyless entry receiver...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P2118 Throttle Control Motor


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2118 ETC MOT-B1 (Throttle actuator control motor current range/performance) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects short in both circuits between ECM and throttle control motor Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (Throttle control motor circuit is shorted...

    Nissan Murano (Z52) 2015-2024 Service Manual: Heater & Air Conditioning Control System :: Preparation. Preparation


    ..

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com