Nissan Murano: Engine / Engine Mechanical :: Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Engine Mechanical :: Removal and Installation

Compression Pressure

On-Vehicle Service CHECKING COMPRESSION PRESSURERun the engine until it reaches normal operating temperature. Turn the ignition switch to OFF. Release fuel pressure and leave the fuel pump electrically disconnected...

Engine Room Cover

Exploded View 1. Engine room cover Removal and Installation CAUTION: Do not damage or scratch engine room cover when installing or removing. REMOVALRemove front air duct...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P1220 Fuel Pump Control Module (fpcm)


DTC Description DTC DETECTION LOGIC DTC No. Trouble diagnosis name (Trouble diagnosis content) DTC detecting condition Possible cause P1220 FPCM (Fuel pump control module) During engine cranking, the signal voltage of the FPCM to the ECM is too low...

Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Tcu


Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor Item Condition Value/Status HF TYPE Ignition switch ON BT AUDIO UNIT TYPE NAVI CALL SWITCH TYPE SOS SPEAKER TYPE INDRCT ZONE USA CHANNEL NISSAN CAN COMM GEN...

Categories

Luggage hooks

Nissan Murano. Luggage hooks

When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

read more

 
Copyright © 2026 www.nimurano.com