Nissan Murano: Engine Mechanical :: Removal and Installation / Air Cleaner and Air Duct

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Engine Mechanical :: Removal and Installation / Air Cleaner and Air Duct

Exploded View

1.	Air duct hose and resonator assembly	2.	Front air duct	3.	Grommet
4.	Air cleaner case (lower)	5.	Grommets	6.	Air cleaner case mounting bracket
7.	Bracket	8.	Air cleaner filter	9.	Air cleaner case (upper)
10.	Mass air flow sensor	A.	Air cleaner case side clips	B.	To electric throttle control actuator. Refer to Exploded View.
	Front

Removal and Installation

REMOVAL

Remove front air duct.

Remove brake fluid level sensor harness connector from brake fluid level sensor.

Remove sub tank bracket from cowl top extension.

Disconnect the tube clamp at the electric throttle control actuator and at the air duct hose and resonator assembly.

Disconnect the blow-by hose. Refer to Exploded View.

Remove air duct hose and resonator assembly.

Disconnect the harness connector from mass air flow sensor.

Remove mass air flow sensor from air cleaner case (upper) (if necessary).

CAUTION:

Handle mass air flow sensor with care.

Do not shock it.

Do not disassemble it.

Do not touch its sensor.

Disconnect the transaxle air breather hose. Refer to Removal and Installation.

Remove bolts and pull air cleaner case (lower) upward to remove from the grommets.

Remove air cleaner assembly.

INSPECTION AFTER REMOVAL

Inspect air cleaner case (upper), air cleaner case (lower), front air duct, air duct and resonator assembly for cracks or tears. Replace as necessary.

INSTALLATION

Installation is in the reverse order of removal.

Engine Room Cover

Exploded View 1. Engine room cover Removal and Installation CAUTION: Do not damage or scratch engine room cover when installing or removing. REMOVALRemove front air duct...

Intake Manifold Collector

Exploded View 1. Intake manifold collector 2. Intake manifold collector gasket 3. Bracket clip 4. Electric throttle control actuator 5...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Icc System Cannot Be Set (main Switch Turns On/off)

Diagnosis Procedure The MAIN switch can be turned ON/OFF, but the ICC system cannot be set even if the SET/COAST switch is pressed.NOTE: The system cannot be set in the following cases: When the Nissan Murano vehicle ahead is not detected below the speed of 32 km/h (20 MPH)...

Nissan Murano (Z52) 2015-2024 Service Manual: On Board Diagnostic (obd) System

Description This is an on board diagnosis system which records diagnosis information related to the exhaust gases. It detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the malfunction indicator lamp (MIL) and are stored as DTC in the ECU memory...