Nissan Murano: Audio, Visual & Navigation System :: Navigation with Bose / Dtc/circuit Diagnosis
- B1305 Control Unit Internal Fault
- B1309 System on
- B1315 Am/fm 1 Antenna
- B1328 External Microphone 1
- B132a External Usb
- B133a Avm Connection
- B1341 Head Unit
- B1346 Gps Antenna Connection
- B1360 Combination Meter
- B1383 Incomp Steering Angle Sensor Adjust
- B13cf Buttons
- B13ec Factory Mode
- U0079 Control Module Communication Bus G Off
- U1000 Can Comm Circuit
- U1300 Av Comm Circuit
- Power Supply and Ground Circuit
- Instrument Panel Tweeter
- Amp on Signal Circuit
- Steering Switches
- Front Auxiliary Input Jacks
Configuration (av Control Unit)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing AV control unit.Configuration has three functions as follows: Function Description
"Before Replace ECU"
Reads the Nissan Murano vehicle configuration of current AV control unit...
B1305 Control Unit Internal Fault
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1305–04
Control unit internal error
(AV control unit internal fault)
[—]
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Exterior Lamp Battery Saver System
System Description SYSTEM DIAGRAMSignal transmission function list Signal name Input Output Description Combination switch signal Combination switch (lighting and turn signal switch) BCM Transmits the combination switch signal to the BCM. High beam request signal BCM IPDM E/R (CAN) Combination meter (CAN) Transmits the high beam request signal via CAN communication...
Nissan Murano (Z52) 2015-2024 Service Manual: Power Supply and Ground Circuit (side Radar Lh)
Work Procedure CHECK FUSES Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 29(10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- High Beam Assist (if so equipped)
- Power Steering Fluid (PSF)
- Checking engine oil level
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
Copyright © 2026 www.nimurano.com