Nissan Murano: Dtc/circuit Diagnosis / U0079 Control Module Communication Bus G Off
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| U0079–00 |
Control module communication Bus G Off (Control module communication Bus G Off) |
[—] | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | CAN communication signal | |||
| Threshold | Transmit or receive is abnormal | |||
| Diagnosis delay time | 2 seconds or more | |||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
CAN communication does not function.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC U0079–00 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC detected again?
YES>>Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.
NO>>Inspection End.
B13ec Factory Mode
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B13EC–52
Factory mode
(AV control unit)
[—]
Diagnosis condition
When ignition switch is ON...
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0776 Pressure Control Solenoid B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0776 PC SOLENOID B (Pressure Control Solenoid “B” Performance/Stuck Off) 1 Diagnosis condition When all of the following conditions are satisfied: DTC other than the applicable DTC is not detected...
Nissan Murano (Z52) 2015-2024 Owners Manual: Cleaning interior
Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuumcleaner or soft bristled brush.Wipe the vinyl and leather (if so equipped) surfaces with a clean, soft cloth dampened in mild soap solution, then wipe clean with a dry, soft cloth...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Shift lock release
- Intelligent Forward Collision Warning (I-FCW)
- Power Steering Fluid (PSF)
- New on site
- Most important about car
Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward
