Nissan Murano: Side Radar (rear Right) (side Radar Rh) / C1b51-16 Blind Spot Warning Indicator Short Circuit
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| C1B51-16 |
BSW/BSI IND SHORT CIR (Blind Spot Warning indicator short circuit) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | – | ||
| Threshold | Short circuit in Blind Spot Warning indicator circuit is detected. (Over current is detected) | ||
| Diagnosis delay time | – | ||
POSSIBLE CAUSE
-
Blind Spot Warning indicator RH circuit
-
Blind Spot Warning indicator RH
-
Side radar RH
FAIL-SAFE
The following systems are canceled:
-
Blind Spot Warning (BSW)
-
Rear Cross Traffic Alert (RCTA)
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine.
-
Select “All DTC Reading” mode.
-
Check if “C1B51-16” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.
Is the “C1B51-16” detected as the current malfunction?
YES>>Refer to Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK BSW INDICATOR CIRCUIT FOR SHORT
-
Turn ignition switch OFF.
-
Disconnect side radar RH harness connector and BSW indicator RH harness connector.
-
Check continuity between side radar RH harness connector and ground.
| Side radar RH |
Ground |
Continuity | |
| Connector | Terminal | ||
| B466 | 4 | No | |
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair the harnesses or connectors.
REPLACE THE BLIND SPOT WARNING INDICATOR
CONSULT
-
Replace the blind spot warning indicator RH.
-
Perform “All DTC Reading”.
-
Check if the “C1B51-16” is detected in “Self Diagnostic Result” of “Side radar (Rear right)”
Is the DTC “C1B51-16” detected?
YES>>Replace the side radar RH. Refer to Removal and Installation.
NO>>Inspection End.
C1b50-49 Side Radar Malfunction
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1B50-49
SIDE RDR MALFUNCTION
(Side radar malfunction)
Diagnosis condition
When ignition switch is ON...
C1b52-17 Blind Spot Warning Indicator Open Circuit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1B52-17
BSW/BSI IND OPEN CIR
(Blind Spot Warning indicator open circuit)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Starting the engine
Apply the parking brake. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate unless the shift lever is in either P (Park) or N (Neutral). Push the ignition switch to the ON position...
Nissan Murano (Z52) 2015-2024 Service Manual: Microphone
Removal and Installation REMOVALRemove the map lamp assembly. Refer to Removal and Installation. Remove the microphone connector from the map lamp assembly . Release the microphone pawls, then remove the microphone . : Pawl INSTALLATIONInstallation is in the reverse order of removal...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- Shift lock release
- System malfunction
- New on site
- Most important about car
Seatback pockets
Theremaybe one or two seatback pockets located on the back of the driver and passenger seats. The pockets can be used to store maps.
WARNING
