Nissan Murano: Automatic Emergency Braking (AEB) (if so equipped) / Turning the AEB system on/off

Nissan Murano (Z52) 2015-2024 Owners Manual / Starting and driving / Automatic Emergency Braking (AEB) (if so equipped) / Turning the AEB system on/off

Nissan Murano. Turning the AEB system on/off

Perform the following steps to turn the AEB system on or off.

  1. Press the Nissan Murano. Turning the AEB system on/off button until “Settings” displays in the vehicle information display and then press the OK button. Use the Nissan Murano. Turning the AEB system on/off button to select “Driver Assistance.” Then press the OK button.
  2. Select “Emergency Brake” and press the OK button.
  3. Select “Front” and press the OK button. When the AEB system is turned off, the AEB system warning light illuminates.

NOTE:

  • The AEB system will be automatically turned on when the engine is restarted.
  • The I-FCW system is integrated into the AEB system. There is not a separate selection in the vehicle information display for the I-FCW system. When the AEB is turned off, the I–FCW system is also turned off.

    AEB system operation

    Vehicle ahead detection indicator AEB warning indicator AEB system warning light The AEB system will function when your vehicle is driven at speeds above approximately 3 mph (5 km/h)...

    AEB system limitations

    WARNING Listed below are the system limitations for the AEB system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: P0746 Pressure Control Solenoid a


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0746 PC SOLENOID A (Pressure Control Solenoid A Performance/Stuck Off) 1 Diagnosis condition When all of the following conditions are satisfied: Engine speed: More than 600 rpm Primary pulley speed: More than 450 rpm Idle is not being detected...

    Nissan Murano (Z52) 2015-2024 Service Manual: B259a Room Lamp Fuse Blown


    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B259A ROOM LAMP FUSE BLOWN (Room lamp fuse blown) Diagnosis condition When ignition switch ON. Signal (terminal) BCM power circuit (terminal 131 and ground) Threshold Approx...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com