Nissan Murano: Dtc/circuit Diagnosis / B1346 Gps Antenna Connection
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B1346–13 |
GPS antenna connection (GPS antenna connection) |
[OPEN] | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | GPS antenna signal to AV control unit (terminal 74) | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1346–11 | [GND–SHORT] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | GPS antenna signal to AV control unit (terminal 74) | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
| B1346–49 | [GND–SHORT] | Diagnosis condition | When ignition switch is ON. | |
| Signal (terminal) | GPS antenna signal to AV control unit (terminal 74) | |||
| Threshold | – | |||
| Diagnosis delay time | 30 seconds or more | |||
POSSIBLE CAUSE
-
GPS antenna is not connected
-
GPS antenna
FAIL-SAFE
Vehicle positions of the navigation screen differ.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1346 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
DETERMINE MALFUNCTION TYPE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV” using CONSULT.
-
Check DTC.
Is DTC B1346–11, 13 or 49 detected?
YES>>13 [OPEN] or 11 [GND–SHORT] – GO TO 2.
YES>>49 [–] – GO TO 3.
NO>>Refer to Intermittent Incident.
CHECK GPS ANTENNA CONNECTOR
-
Ignition switch OFF.
-
Visually check GPS antenna connection.
Is the inspection result normal?
YES>>Replace GPS antenna. Refer to Removal and Installation.
NO>>Repair connection of GPS antenna to AV control unit.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1346–49 detected?
YES>>Replace AV control unit. Refer to Removal and Installation.
NO>>Inspection End.
B1341 Head Unit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1341–16
Head unit
(AV control unit)
[VB–LOW]
Diagnosis condition
When ignition switch is ON...
B1360 Combination Meter
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1360–02
Combination meter
(Combination meter connection error)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Vehicle recovery (freeing a stuck vehicle).
WARNING To avoid vehicle damage, serious personal injury or death when recovering a stuck vehicle: Contact a professional towing service to recover the vehicle if you have any questions regarding the recovery procedure. Tow chains or cables must be attached only to main structural members of the vehicle...
Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Adas Control Unit 2
Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Condition Value/Status MAIN SW Ignition switch ON When MAIN switch is pressed On When MAIN switch is not pressed Off SET/COAST SW Ignition switch ON When SET/COAST switch is pressed On When SET/COAST switch is not pressed Off CANCEL SW Ignition switch ON When CANCEL switch is pressed On When CANCEL switch is not pressed Off RESUME/ACC SW Ignition switch ON When RESUME/ACCELERATE switch is pressed On When RESUME/ACCELERATE switch is not pressed Off DISTANCE SW Ignition switch ON When DISTANCE switch is pressed On When DISTANCE switch is not pressed Off CRUISE OPE Drive the Nissan Murano vehicle and activate the vehicle-to-vehicle distance control mode When ICC system is controlling On When ICC system is not controlling Off BRAKE SW Ignition switch ON When brake pedal is depressed Off When brake pedal is not depressed On STOP LAMP SW Ignition switch ON When brake pedal is depressed On When brake pedal is not depressed Off IDLE SW Engine running Idling On Except idling (depress accelerator pedal) Off VHCL SPEED SE While driving Displays the Nissan Murano vehicle speed calculated by ADAS control unit ENGINE RPM Engine running Equivalent to tachometer reading THRTL SENSOR NOTE: The item is displayed, but it is not used...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- Vehicle Dynamic Control (VDC) OFF switch
- Passenger compartment
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
