Nissan Murano: Audio, Visual & Navigation System :: Navigation with Bose / Removal and Installation

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Navigation with Bose / Removal and Installation

Normal Operating Condition

Description RELATED TO NOISEThe majority of the audio concerns are the result of outside causes (bad CD, electromagnetic interference, etc.).The following noise results from variations in field strength, such as fading noise and multi-path noise, or external noise from trains and other sources...

Av Control Unit

Exploded View 1. AV control unit bracket (RH) 2. AV control unit 3. AV control unit bracket (LH) 4. A/C auto amp. Removal and Installation REMOVALCAUTION: Before disconnecting the AV control unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0196 Eot Sensor


DTC Description DTC DETECTION LOGIC Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage signals from EOT sensor and intake air temperature sensor. The comparison result of signals transmitted to ECM from each temperature sensor (IAT sensor, ECT sensor, FTT sensor, and EOT sensor) shows that the signal voltage of the EOT sensor is higher/lower than that of other temperature sensors when the engine is started with its cold state...

Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Transaxle Assembly


Description Perform the following work after the transaxle assembly is replaced. For work procedure, refer to Work Procedure.NOTE: The CD provided with the new transaxle assembly contains important calibration data that must be installed with CONSULT after installation of the new transaxle assembly...

Categories

Fuel gauge

Nissan Murano. Fuel gauge

The gauge indicates the approximate fuel level in the tank.

The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

read more

 
Copyright © 2026 www.nimurano.com