Nissan Murano: Removal and Installation / Gps Antenna
Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to Removal and Installation.
Remove screw to remove GPS antenna from instrument panel.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALLower headlining (rear). Refer to Exploded View.
Disconnect the harness connectors from the antenna feeder.
Loosen bolt (A) and remove roof antenna (1)...
Removal and Installation
REMOVALRemove front room\map lamp assembly. Refer to Removal and Installation.
Disconnect the harness connector (A) from front room\map lamp assembly (2)...
Other information:
Diagnosis Procedure
ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the short-circuited sensor...
Diagnosis Procedure
Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.NOTE:
The engine start function, door lock function, power distribution system, and NATS-IVIS in the Intelligent Key system are closely related to each other regarding control...
Categories

Your vehicle has two types of security systems:
Vehicle security system
NISSAN Vehicle Immobilizer System
The vehicle security system provides visual
and audible alarm signals if someone
opens the doors, liftgate or the hood when
the system is armed. It is not, however, a
motion detection type system that activates
when a vehicle is moved or when a
vibration occurs.
read more