Nissan Murano: Removal and Installation / Roof Antenna
REMOVAL
Lower headlining (rear). Refer to Exploded View.
Disconnect the harness connectors from the antenna feeder.
Loosen bolt (A) and remove roof antenna (1).
INSTALLATION
Installation is in the reverse order of removal.
| Roof antenna nut | : 8 N·m (0.82 kg-m, 71 in-lb) |
CAUTION:
If the roof antenna nut is not tightened to the specified torque, lower sensitivity of the antenna may be experienced. If the nut is tightened tighter than the specified torque, this will deform the roof panel.
DISASSEMBLY
Using a suitable tool, release pawls between roof antenna (2) and the cover (1).
 |
: Pawl |
Remove the cover from roof antenna.
ASSEMBLY
Assembly is in the reverse order of disassembly.
Bose Speaker Amp
Exploded View
1.
Rear seat support bracket
2.
BOSE speaker amp. bracket
3.
BOSE speaker amp.
Front
Removal and Installation
REMOVALRemove luggage floor front finisher...
Gps Antenna
Removal and Installation
REMOVALRemove instrument panel assembly. Refer to Removal and Installation.
Remove screw to remove GPS antenna from instrument panel...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Evap Canister
Exploded View EVAP CANISTER 1. EVAP canister control pressure sensor 2. EVAP canister 3. Shield 4. Clamp 5. EVAP canister purge hose 6. EVAP canister vent line 7. EVAP canister vent control valve hose 8. EVAP canister vent control valve A...
Nissan Murano (Z52) 2015-2024 Service Manual: Fluid Cooler Fluid Warmer System
System Description CVT FLUID COOLER SCHEMATICCOMPONENT DESCRIPTIONCVT Oil Warmer The CVT oil warmer (1) is installed on the front part of transaxle assembly. When engine is started while engine and CVT are cold, engine coolant temperature rises more quickly than CVT fluid temperature...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- Fuel recommendation
- Rear bench seat adjustment
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
