Nissan Murano: Meters and gauges / Fuel gauge
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.
The low fuel warning message shows in the vehicle information display when the amount of fuel in the tank is getting low.
Refill the fuel tank before the gauge registers 0 (Empty).
The 
indicates that the fuel-filler
door is located on the driver’s side of the
vehicle.
CAUTION
- If the vehicle runs out of fuel, the
Malfunction Indicator Light (MIL)
may
come on. Refuel as soon as possible.
After a fewdriving trips, the 
light
should turn off. If the light remains on
after a few driving trips, have the vehicle
inspected. It is recommended
that you visit a NISSAN dealer for this
service. - For additional information, refer to “Malfunction Indicator Light (MIL)” in this section.
Engine coolant temperature gauge
The gauge indicates the engine coolant
temperature.The engine coolant temperature
is within the normal range when
the gauge needle points within the zone
shown in the illustration...
Distance To Empty (DTE)
Displays the estimated distance the vehicle
can be driven before refueling. The
value is calculated based on recent fuel
economy, the amount of fuel remaining in
the fuel tank, and the actual fuel consumption...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U0079 Control Module Communication Bus G Off
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0079–00 Control module communication Bus G Off (Control module communication Bus G Off) [—] Diagnosis condition When ignition switch is ON...
Nissan Murano (Z52) 2015-2024 Service Manual: System. Awd System
System Description SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNALIt transmits/receives each signal from the following AWD control unit via CAN communication line: Component parts Function ABS actuator and electric unit (control unit) Transmits the following signals via CAN communication to AWD control unit: Nissan Murano Vehicle speed signal Stop lamp switch signal (brake signal) Yaw rate sensor signal Side G sensor signal Decel G sensor signal ECM Transmits the following signals via CAN communication to AWD control unit: Accelerator pedal position signal Engine speed signal TCM Transmits the following signals via CAN communication to AWD control unit: Input shaft revolutional signal CVT ratio signal Combination meter Transmits conditions of parking brake switch signal via CAN communication to AWD control unit...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Jacking up vehicle and removing the damaged tire
- GAS STATION INFORMATION
- Tire rotation
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.
Copyright © 2026 www.nimurano.com