Nissan Murano: Removal and Installation / Microphone
Removal and Installation
REMOVAL
Remove front room\map lamp assembly. Refer to Removal and Installation.
Disconnect the harness connector (A) from front room\map lamp assembly (2).

Release pawls and remove microphone (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALRemove instrument panel assembly. Refer to Removal and Installation.
Remove screw to remove GPS antenna from instrument panel...
Other information:
DTC Description
DESCRIPTIONThis ECM contains a timer and measures time between an ignition switch OFF and the next ignition switch ON. This enables the judging of the state of engine cooling at an engine start.DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P2610
ECM/PCM INTERNAL ENG OFF TIMER
(ECM/PCM internal engine off timer performance)
1
Diagnosis condition
—
Signal (terminal)
—
Threshold
ECM internal engine off timer is malfunctioning
Diagnosis delay time
—
2
Diagnosis condition
—
Signal (terminal)
—
Threshold
The time calculated by ECM based on a descent allowance of engine coolant temperatures during ignition switch OFF is extremely shorter than the time counted by the Engine internal OFF timer
Diagnosis delay time
—
POSSIBLE CAUSE
ECM
ECM power supply
FAIL-SAFENot applicable
DTC Confirmation Procedure
INSPECTION START
It is necessary to erase permanent DTC?
YES>>
GO TO 4...
Use the following process to setup key-link:
Unlock the vehicle with the desired Intelligent
Key while the ignition is OFF.
Place the ignition in the ON position.
Within the “Settings” menu of the vehicle
information display, select “Key-
Linked Settings” and press the OK button
on the steering switch...