Nissan Murano: Removal and Installation / Front Auxiliary Input Jacks
Removal and Installation
REMOVAL
Remove shift selector finisher. Refer to Exploded View.
Release pawls and remove front auxiliary input jacks (1).

: Pawl
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
RemovalRemove A/C switch assembly Removal and Installation.
Disconnect the harness connectors from the front auxiliary input jacks control unit...
Removal and Installation
REMOVALRemove instrument panel tweeter grille (LH\RH). Refer to Exploded View.
Disconnect the harness connector from instrument panel tweeter and remove screws (A) to remove instrument panel tweeter (1)...
Other information:
Component Function Check
CHECK FUNCTION
CONSULT
Select “REQ SW-DR” or “REQ SW-AS” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”.
Check that the function operates normally according to the following conditions:
Monitor Item Condition Status
REQ SW -DR
LH door request switch
Pressed
ON
Released
OFF
REQ SW -AS
RH door request switch
Pressed
ON
Released
OFF
Is the inspection result normal?
YES>>
Front door request switch is OK...
Diagnosis Procedure
CHECK INTAKE MODE DOOR MOTOR POWER SUPPLY
Ignition switch ON.
Check voltage between intake mode door motor harness connector and ground.
+ −
Voltage
(Approx.)
Intake mode door motor
Connector Terminal
M153
1
Ground
Battery voltage
Is the inspection result normal?
YES>>
GO TO 2...