Nissan Murano: Removal and Installation / Bose Speaker Amp
Exploded View

| 1. |
Rear seat support bracket |
2. |
BOSE speaker amp. bracket |
3. |
BOSE speaker amp. |
 |
Front |
|
|
|
|
Removal and Installation
REMOVAL
Remove luggage floor front finisher. Refer to Exploded View.
Remove luggage floor side finisher (RH). Refer to Exploded View.
Disconnect the harness connector from the BOSE speaker amp.
Remove BOSE speaker amp. bracket bolts to remove BOSE speaker amp. and BOSE speaker amp. bracket as an assembly.
Separate BOSE speaker amp. from BOSE speaker amp. bracket (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Exploded View
1.
Subwoofer clamp
2.
Subwoofer
3.
Spare tire
Front
Removal and Installation
REMOVALRemove storage box lid. Refer to Removal and Installation...
Removal and Installation
REMOVALLower headlining (rear). Refer to Exploded View.
Disconnect the harness connectors from the antenna feeder.
Loosen bolt (A) and remove roof antenna (1)...
Other information:
Component Function Check
CHECK FUNCTION
CONSULT
Select “UNLK SEN-DR” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”.
Check that the function operates normally according to the following conditions:
Monitor Item Condition Status
UNLK SEN -DR
Driver side door
Lock
OFF
Unlock
ON
Is the inspection result normal?
YES>>
Unlock sensor is OK...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1328–13
External Microphone 1
(Microphone)
[OPEN]
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
–
Diagnosis delay time
30 seconds or more
B1328–11
[GND–SHORT]
Diagnosis condition
When ignition switch is ON...